Often asked: How To Turn On Gas Water Heater Pilot Light?

How can I tell if my water heater pilot light is on?

It’s usually right on the panel. Turn and hold the knob to “Pilot” and push the ignitor. You should hear it click, and probably also a “whooshing” sound. Check in that gap, and you should see the light on.

How do you turn a pilot light back on?

How to Relight a Pilot Light: 5 Steps

  1. Find the pilot light assembly and its reset switch. The furnace’s pilot light is usually positioned at the bottom of the unit by a knob.
  2. Set the reset switch to off. Turn the knob to the “Off” setting.
  3. Wait a moment.
  4. Relight the pilot light.
  5. Observe the furnace.

Do I need to turn gas off if pilot light goes out?

If the pilot light goes out on a storage or instantaneous hot water heater, space heater or a ducted heater, you will not have a gas leak. This is because all modern gas appliances with pilot lights have a fail-safe device that closes off the gas to the appliance in the case when the pilot may go out.

You might be interested:  Often asked: How To Test A Refrigerator Defrost Heater?

What do you do when the pilot light goes out on your water heater?

What should you do when your water heater’s pilot light goes out?

  1. Turn the thermostat to the lowest setting.
  2. Turn the on/off/pilot switch to the “pilot” position.
  3. Remove the outer and inner panels to access your pilot light.

How much does it cost to relight a pilot?

Most service providers will charge a standard fee per visit that typically covers the cost to relight a gas water heater. This service call price can range from $80 to $100. Have you ever relit your own pilot light?

Should the pilot light always be on in a gas heater?

Most furnaces with electronic ignition have a device called a hot surface igniter. The difference is that the flame is only lit (by an electronic spark) when your furnace is ready for a heating cycle. When the pilot light is not needed, it is completely off, saving you money on gas.

Can I manually light my gas water heater?

Lighting the Pilot Light on a Manual Hot Water Heater If your hot water heater is a manual, grab a long lighter. Turn the pilot dial to the off position and wait 5-10 minutes for any gas to dissipate. Then, turn the pilot dial until it says the word pilot. After that, set your temperate knob to low.

Why is my gas water heater not working?

If a gas water heater isn’t heating, a common problem is usually that the pilot light has gone out. This may be caused by the gas valve, the natural gas supply, or—more likely—the thermocouple located next to the pilot light.

You might be interested:  FAQ: How Long Does It Take A 50 Gallon Water Heater To Heat Up?

Does a gas water heater have a reset button?

A water heater reset button, usually red, is located in the center of the limit switch just above the water heater thermostat. The water heater limit switch is a safety device that will shut the power down to the water heater if something malfunctions and the water gets to hot.

Will you smell gas if pilot light goes out?

This system will allow a small amount of gas to leak through the pilot tubing. If the pilot light is out, the gas must be shut off at the appliance isolation valve, normally located in close proximity to the appliance. If you notice an odor of gas, contact Peoples’ emergency number at 1-800-400-4271.

Can you get carbon monoxide poisoning from a pilot light?

A pilot light should be a crisp blue colour. A yellow or orange pilot light will produce carbon monoxide – an odourless, colourless gas that can fill your home and cause carbon monoxide poisoning. Symptoms of this condition include dizziness, headache, fatigue, nausea, unconsciousness, brain damage and death.

Can a pilot light out cause carbon monoxide?

Carbon monoxide is only produced when fuel of any type; oil, gas, wood or coal is burned. And a pilot light out of adjustment can produce carbon monoxide gas. The amount produced by even a badly maladjusted pilot is small because the flame size is also small.

Leave a Reply

Your email address will not be published. Required fields are marked *