Readers ask: How To Check Pilot Light On Water Heater?

How do I know if my pilot light is out?

How to Tell If the Pilot Light Is Out

  1. Locate the front cover panel on your furnace. It should be a little door that’s easily visible.
  2. If your pilot light is on, it should be easy to see – your eyes will be drawn to the little flame.
  3. If you don’t see a flame, your pilot light is out.
  4. If there is a flame, check the color.

What happens if water heater pilot light goes out?

If the pilot light goes out, your water heater won’t be able to ignite the gas burner and therefore, won’t be able to heat the water. But once the pilot light is relit, the water heater is able to ignite the gas burner and can begin to heat the water again.

What should I do if my pilot light goes out?

Your pilot light relies on your natural gas to stay aflame, so if your gas is shut off, your pilot light will go out. Simply turn your gas back on and either relight your pilot light yourself or call a professional.

You might be interested:  Readers ask: How To Size A Pool Heater?

What do I do if my pilot light won’t light?

How to Fix Your Pilot Light

  1. Find your gas valve.
  2. You need to turn the valve to the off position for at least three minutes.
  3. Once you have had the valve at off for a few minutes, switch it over to pilot setting.
  4. You will need a match that is lit.
  5. Set the pilot valve to the on position.

Why is my water heater not igniting?

The water heater pilot light is a small flame that ignites the gas burner on your water heater. If the pilot doesn’t relight, if it goes out right after lighting or if it goes out repeatedly, by far the most common cause is a bad thermocouple.

Does gas still flow when pilot light goes out?

If your pilot light repeatedly goes out, this is a likely culprit. If this flame sensor should fail, gas will continue to flow even after the pilot light has been extinguished, causing a safety hazard, and requiring immediate repair.

Can I relight the pilot light by myself?

If your pilot light goes out, your furnace will not be able to produce heat because its burners will not ignite. Often, homeowners can relight the pilot themselves.

Should pilot light always be on water heater?

The pilot should be on the water heating the house. The pilot flame can be difficult to see through a window. To know if the pilot is on or off, you need to remove the access door and shield and look at the burner and pilot through it.

You might be interested:  FAQ: How Water Heater?

Can you get carbon monoxide poisoning from a pilot light?

A pilot light should be a crisp blue colour. A yellow or orange pilot light will produce carbon monoxide – an odourless, colourless gas that can fill your home and cause carbon monoxide poisoning. Symptoms of this condition include dizziness, headache, fatigue, nausea, unconsciousness, brain damage and death.

Why is my pilot light going out?

Sometimes a pilot light can go out as a result of some source of wind or air simply blowing it out. If this happens, there could be an issue with how your flue pipe is set up or how your system is venting.

How much does it cost to replace a thermocouple?

The thermocouple is an apparatus that senses whether the pilot light is lit and triggers the gas control valve. Repairs typically cost about $150 to have it done professionally, though a new thermocouple itself only costs about $20 on average.

How do you clean a pilot light?

How to Clean a Pilot Light

  1. Cut off the gas to your furnace.
  2. Remove the pilot light and thermocouple assembly.
  3. Use your pliers or wrench to remove the pilot light and thermocouple from the bracket.
  4. Using the wire brush, brush away the carbon buildup and soot from both components.

Leave a Reply

Your email address will not be published. Required fields are marked *