Readers ask: How To Lite A Water Heater?

How do you light a hot water heater?

Turn the water heat dial to Low and the On/Off/Pilot dial to Pilot. Then, turn the On/Off/Pilot dial downwards and push the igniter button at the same time. Let go of the igniter button, but keep pressing the Pilot dial downward for around 30 seconds. You should hear a “whoosh” sound when the gas is lit.

Can you manually light a hot water heater?

Lighting the Pilot Light on a Manual Hot Water Heater If your hot water heater is a manual, grab a long lighter. Turn the pilot dial to the off position and wait 5-10 minutes for any gas to dissipate. Then, turn the pilot dial until it says the word pilot. After that, set your temperate knob to low.

How do you reset the pilot light on a water heater?

Once the pilot lights, keep holding the knob/button down for around one minute. After that time, slowly release the knob/button and check that there’s still a flame coming from the pilot. Go back to the gas valve and turn the knob to “On.” Usually you’ll hear a noise indicating the main burner is igniting.

You might be interested:  Question: Why Does Water Heater Flame Go Out?

What do I do if my water heater won’t light?

If you have a natural or propane gas water heater, chances are the pilot has gone out. If the pilot doesn’t relight, if it goes out right after lighting or if it goes out repeatedly, by far the most common cause is a bad thermocouple.

What do you do when you have no hot water?

Solved! What to Do When There’s No Hot Water

  1. Bump up the thermostat.
  2. Relight the pilot light.
  3. Fix a faulty thermocouple.
  4. Rekindle a blue flame.
  5. Inspect the gas line.
  6. Restart your water heater.
  7. Reset the circuit breaker.
  8. Call in the professionals.

Can I relight the pilot light by myself?

If your pilot light goes out, your furnace will not be able to produce heat because its burners will not ignite. Often, homeowners can relight the pilot themselves.

Can you manually light a water heater with electronic pilot?

* Caution: Most modern water heaters no longer use standing pilots. They use electronic ignition to ignite the gas. Do not attempt to manually light an electronic ignition system. If the pilot light will not re-light, the problem could be a clogged pilot line or orifice, or gas is not reaching the water heater.

Is it safe to relight a pilot light?

Yes, it is safe to light a pilot light with a gas lighter. If you are trying to relight the pilot light, before turning the knob to the pilot position, wait for some time until the gas smell goes away. If you follow these instructions, it is safe to light a pilot light using gas lighter.

You might be interested:  Question: How To Shop For A Water Heater?

Can a water heater explode?

Water heater explosions are terrifying, and they can happen. Anything that causes excess pressure on your water heating system, such as a poor anode rod, or a lot of sediment buildup, can all cause your water heater to explode. A gas leak can also cause your water heater to explode because it is a tremendous fire risk.

How do you light a hot water heater without an igniter?

Lighting with No Igniter

  1. Take a long lighter to reach the pilot.
  2. Remove the plate attached below the dial box.
  3. Switch Pilot to OFF.
  4. Wait for a while, – 5-10 minutes until there won’t be any gas.
  5. Change the temperature to LOW, and switch to Pilot.
  6. Push ON/OFF dial down, and simultaneously use the lighter.

Why is my electric water heater not getting hot?

Water temperature problems When there’s no hot water, the problem can stem from lack of power, a faulty electric thermostat or a faulty upper electric heating element. Start by ruling out power problems. First, reset any tripped circuit breaker, and replace any blown fuse.

How long do water heaters last?

How Long Do Water Heaters Last? Based on the manufacturer’s suggested service life, the life expectancy of a water heater is about eight to 12 years. That varies with the location and design of the unit, quality of installation, maintenance schedule and water quality.

Does an electric water heater have a pilot light?

There’s no gas or pilot light involved in electric water heaters. If the power to your electric water heater is off, you may have an electrical issue requiring professional assistance. You will need to reignite a gas water heater that does not light automatically.

You might be interested:  FAQ: How To Lite A Hot Water Heater?

How do I know if the pilot light is out on my water heater?

It’s usually right on the panel. Turn and hold the knob to “Pilot” and push the ignitor. You should hear it click, and probably also a “whooshing” sound. Check in that gap, and you should see the light on.

Leave a Reply

Your email address will not be published. Required fields are marked *