Readers ask: How To Turn On Water Heater Pilot?

How do I light the pilot on my water heater?

How to Light a Water Heater Pilot Light

  1. Open the door/cover over the pilot light access.
  2. Use a flashlight or a headlamp to find the burner inside.
  3. Turn the gas knob to “Pilot,” press and hold it down.
  4. While still holding the gas down, light that pilot.

How can I tell if my water heater pilot light is on?

It’s usually right on the panel. Turn and hold the knob to “Pilot” and push the ignitor. You should hear it click, and probably also a “whooshing” sound. Check in that gap, and you should see the light on.

Why can’t I light the pilot on my water heater?

The water heater pilot light is a small flame that ignites the gas burner on your water heater. If the pilot doesn’t relight, if it goes out right after lighting or if it goes out repeatedly, by far the most common cause is a bad thermocouple.

You might be interested:  FAQ: Rheem Water Heater How To Light Pilot?

Can I relight the pilot light by myself?

If your pilot light goes out, your furnace will not be able to produce heat because its burners will not ignite. Often, homeowners can relight the pilot themselves.

Is it safe to relight a pilot light?

Yes, it is safe to light a pilot light with a gas lighter. If you are trying to relight the pilot light, before turning the knob to the pilot position, wait for some time until the gas smell goes away. If you follow these instructions, it is safe to light a pilot light using gas lighter.

What happens if you turn on an empty water heater?

overheating and rapid chilling will cause the tank lining to fail, this won’t be immediately apparent, in gas-fired water heaters fired without water, overheating and rapid chilling will cause the tank lining to fail, this won’t be immediately obvious.

How does a gas water heater work without electricity?

Gas Conventional Tank Water Heater – These heaters typically don’t use electricity, and rely solely on the use of a pilot light and gas ignition for heat. As a result, these heaters will usually work during a power outage.

Can I turn my water heater off?

Just locate the relief valve, usually near or at the top of the water heater. Turn the valve off and air will now be allowed to enter the tank. That’s it!

Do I need to turn gas off if pilot light goes out?

If the pilot light goes out on a storage or instantaneous hot water heater, space heater or a ducted heater, you will not have a gas leak. This is because all modern gas appliances with pilot lights have a fail-safe device that closes off the gas to the appliance in the case when the pilot may go out.

You might be interested:  Often asked: What Is The Average Cost Of A Water Heater?

Should pilot light always be on water heater?

The pilot should be on the water heating the house. The pilot flame can be difficult to see through a window. To know if the pilot is on or off, you need to remove the access door and shield and look at the burner and pilot through it.

How do you know if you have a bad thermocouple?

If you can’t get the flame to light at all, and you’re sure the gas is on, there’s probably an obstruction in the pilot tube. If the flame lights and goes out when you release the gas control knob after holding it in for the recommended 20 to 30 seconds, that’s the sign of a thermocouple malfunction.

Can I manually light my gas water heater?

Lighting the Pilot Light on a Manual Hot Water Heater If your hot water heater is a manual, grab a long lighter. Turn the pilot dial to the off position and wait 5-10 minutes for any gas to dissipate. Then, turn the pilot dial until it says the word pilot. After that, set your temperate knob to low.

What do I do if my pilot light won’t light?

How to Fix Your Pilot Light

  1. Find your gas valve.
  2. You need to turn the valve to the off position for at least three minutes.
  3. Once you have had the valve at off for a few minutes, switch it over to pilot setting.
  4. You will need a match that is lit.
  5. Set the pilot valve to the on position.

Leave a Reply

Your email address will not be published. Required fields are marked *