Readers ask: What Temp For Water Heater?

Is 130 too hot for water heater?

Professionals recommend keeping your water heater set at a temperature between 130 and 140 degrees Fahrenheit. Any higher, or lower, could actually be dangerous for you and your family. While turning the temperature up higher can result in burns, turning it lower than the recommended setting can also be dangerous.

What should my hot water tank thermostat be set at?

The short answer: 120 degrees Fahrenheit. This is the preset thermostat temperature in most new water heaters, and it’s the recommended setting of the U.S. Department of Energy. At this temperature, harmful pathogens like the kind that cause Legionnaires’ disease are prevented from multiplying and may be killed.

Is 150 too hot for water heater?

The recommended setting for household water heaters is not 150 degrees, but slightly less _ 140 degrees. Water temperatures higher than 140 degrees can burn the skin and are particularly dangerous for young children and the elderly. People with poor circulation can scald themselves without knowing it.

You might be interested:  How To Light Water Heater With Automatic Pilot?

Is 140 degrees to hot for water heater?

The standard temperature for most water heaters is 140 degrees F, but the Department of EnergyLink opens in a new tab recommends turning down the temperature to 120 degrees to save energy.

Is 125 degrees to hot for water heater?

What’s a safe temperature for water? On the side of most water heaters, you’ll find a warning that says water temperatures of 125 degrees Fahrenheit can cause burns or death. To be safe, the water coming out of the plumbing fixtures in a home shouldn’t be any hotter than 120 degrees.

Is 135 too hot for water heater?

The American Society of Sanitary Engineering recommends that hot water tanks be set from 135 to 140 degrees, to inhibit the growth of Legionella bacteria, with the installation of anti-scald devices and tempering valves to prevent hot water injuries.

Does turning up water heater make hot water last longer?

Turn up the thermostat on the hot water heater. One of the easiest ways to make a hot shower last longer is by using less hot water while it’s at a higher temperature. To do this, turn up the temperature on the thermostat that’s attached to the hot water heater tank. Be conscious of other hot water in your home.

What temperature should I set my hot water heater ABC?

Know the Ideal Setting: The best setting for gas water heaters is around 115 to 120 degrees Fahrenheit. Oftentimes, water heaters will have additional options to either lower or increase the temperature of the water inside. In the case of the video’s water heater, A, B and C each have an increase of about 10 degrees. 6

You might be interested:  Question: How Much Propane Will A 30000 Btu Heater Use?

What is the maximum temperature for a hot water heater?

A new water heater is typically preset to a maximum temperature of 140 degrees Fahrenheit. Some say that’s the ideal temperature, while others argue that it’s better to reduce the maximum temperature to 120.

What is a safe water temperature for a bath?

The optimal temperature for shower water or bath water, so that it washes away environmental dirt and bacteria, is no higher than 112 degrees Fahrenheit, Cleveland Clinic dermatologist Melissa Piliang says. Few things feel better than a hot soak on a cold day.

Is 50 degrees hot enough for hot water?

Water that is 57 degrees can cause a major burn within a few seconds. This highlights just how dangerous water can be over the 50 degree temperature mark even if it is only a few degrees. In the case of how hot is too hot, the absolute maximum should be 50 degrees for every appliance located in a bathroom area.

Leave a Reply

Your email address will not be published. Required fields are marked *